RS fabrications

Local Banbury bike enthusiast Pete Stanley asked if a decat conversion to his Suzuki GSXR would give him the performance gain he was after? Well the answer is yes! To increase performance for the Trackday Special, the catalytic converter was removed and a link pipe was fabricated. This joined the standard 4 cylinder exhaust system, with the 4 into [...]

Local VW customizer Jamie has transformed a few VW’s in his time. He has even had his hands on the Passat Wagon, that is Shane’s daily runner at the moment. For his Golf VR6 creation, Jamie wanted something a little different for the exhaust, and that was precisely what he got!! Cat back in 2.5″ Stainless Steel with a single rear [...]

Mike, ex Windsor & Maidenhead Engineering Head of Department, see link http://www.rsfabrications.com/2009/07/17/1950-frazer-nash-the-pupil-has-become-the-master/came down to the workshop in Banbury with his Classic 911 Turbo. Having just received a full engine re-build and uprated turbo, Mike wanted to finish the job with an RS Fabrications Silencer and Twin Tailpipes Performance Exhaust System. The aftermarket Turbo Downpipe, supplied by Mike, [...]

Joey Smith, one of the Smiths of Bloxham Boys, dropped into RS Fabrications to get “measured up” for a system on his 5 Series BMW M Sport. Joey was after the M5 look with the 4 rear tailpipe set-up. A replacement Carbon Fibre rear panel was purchased and the BMW was booked in. Joey had his mate [...]

Local Banbury Lad Carlos Lane, knows quality and knew what he wanted for his Subaru. Shane specified a twin box  full stainless steel system with Carlos opting for a 4″ Rolled In Polished tailpipe to finish it off. With the original system removed, the new performace item was hand fabricated between Shane & Tony, with Shane finish [...]

Jason Tubb came to RS Fabrications to get the final touches to his immaculate GT40. 3 years in the creation, Jason wanted the perfect exhaust system to complete the engine bay in the vehicle. Jason has painstakingly put this GT 40 together, starting with a Stainless Steel Chassis and systematically working through each item and finishing [...]

Jon Stangle, of Stangle Preparation Ltd, last campaigned his Darrian T90 on the Killarney International Rally of the lakes in 2009. The T90, at that time, was running a Cosworth BDG on injection, but since then Jon has installed a Honda S2000 lump. The engine was mated to the Hewland  Gearbox, designed and modified  by Jon himself [...]

News is getting round that RS Fabrications is the place to bring your Porsche for a complete performance exhaust or a modification to an existing item. First up was Henry, a Warwickshire Businessman, and he wanted modification to the exhaust on his GT3. Henry was very specific, and wanted the the exit pipes on the vehicle ending  with twin [...]

Darryl, local High Wycombe Heating Engineer, came up to RS Fabrications, with his wife Wendy, to visit the facility and see what  RS Fabrications could do for his pride and joy, a 1991 Ford Granada Cosworth. Darryl has upgraded his ride over the years, and he is very specific on the parts required, considering the current tuning on [...]

RS Fabrications Apprentice Ben Scott, on the right, and James Matthews completed their 1st full exhaust system together on the RS Fabrications Audi A4 Avant. Ben Scott, known as Ben 10 to his colleagues, has recently joint the RS team and has been signed up as the RS Apprentice due to his fabrication skills and [...]